Fagor 8065 - Page 36

Error solving manual.
CNC 8060
CNC 8065
·36·
(REF: 1709)
1212 '#CALL AX/#SET AX: repeated axis number.
DETECTION During execution.
CAUSE Two axes try to occupy the same position in the channel.
SOLUTION Check the program.
1213 '#CALL AX/#SET AX: not allowed when G63 is active'
DETECTION During execution.
CAUSE #CALL AX cannot be programmed if function G63 is active.
SOLUTION Deactivate the threading G63 before modifying the configuration of the axes.
1214 '#CALL AX/#SET AX: too many axes required'
DETECTION During execution.
CAUSE Too many axes programmed; the number of axes exceeds the number of axes of the
system.
SOLUTION Check the configuration of the axes of a channel The number of axes of a channel
cannot exceed the number of axes of the system.
1215 'The #CALL AX/#SET AX instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program.
1216 '#CALL AX/#CAX: axis name being used'
DETECTION During execution.
CAUSE The name of one of the axes is being used by a C axis.
SOLUTION Check the program.
1217 '#CALL AX: index being used'
DETECTION During execution.
CAUSE One of the positions is occupied by another axis.
SOLUTION Check the configuration of the axes defined for the channel, two axes cannot be in
the same position. An axis can use any free position between 1 and a number equal
to the maximum number of axes plus the maximum number of spindles allowed by
the system.
1218 'The #FREE AX instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program.
1219 '"," or "]" expected'
DETECTION During execution.
CAUSE Syntax error in the instruction.
SOLUTION Check the program.
1220 '#FREE AX: an active axis cannot be eliminated in manual mode'
DETECTION During execution.
CAUSE An axis in additive manual mode G201 cannot be eliminated from the channel.
SOLUTION Use function G202 to cancel the additive manual mode of the axis in order remove
the axis from the channel.
1221 'The #SET AX instruction must be programmed alone in the block'
DETECTION During execution.
CAUSE The instruction has not been programmed alone in the block.
SOLUTION Check the program.
1222 '#COMMENT END not expected'
DETECTION During execution.
CAUSE There is an end-of-comment block (#COMMENT END), but the open-comment block
(#COMMENT BEGIN) is missing.
SOLUTION Check the program.