Error solving manual.
CNC 8060
CNC 8065
·38·
(REF: 1709)
1240 'Nonexistent axis'
DETECTION During execution.
CAUSE The macro is not defined in the program.
SOLUTION Define the macro before using it. The macro may be defined in a program.
The CNC stores in a table the macros defined in a program or in MDI/MDA mode so
they are available for all the programs executed afterwards. The CNC initializes the
table of macros on start-up or with the instruction #INIT MACROTAB.
1241 'The replacement text of the macro is missing'
DETECTION During execution.
CAUSE The replacement text associated with the macro is an empty string of characters.
SOLUTION Associate the proper replacement text with the macro according to the functionality
it should have. The replacement text must be written between quote marks.
1244 'Face axis close to the center: the spindle speed in G96 has been limited'
DETECTION During execution.
CAUSE When working at constant surface speed (G96), the CNC has limited the spindle
speed because the face axis is very close to the center of rotation.
SOLUTION Increase the speed limit (G192) or accept the limitation.
1245 'G96: no face axis (FACEAXIS) has been defined in the active plane'
DETECTION During execution.
CAUSE None of the axes of the plane has been defined as face axis.
SOLUTION Define one of the axes of the main plane as face axis (parameter FACEAXIS).
1246 'Threading is not possible with feedrate in G95'
DETECTION During execution.
CAUSE An attempt has been made to execute a rigid tapping (G63) while function G95 is
active (feed per spindle revolution).
SOLUTION Activate the feedrate as a function of time (G94)
1247 'Threading is not possible while G96 is active'
DETECTION During execution.
CAUSE The CNC has tried to execute a rigid tapping (G63) while function G96 is active
(constant surface speed).
SOLUTION Activate the constant turning speed mode (G97).
1248 'Threading and G192 not allowed in the same block'
DETECTION During execution.
CAUSE The CNC does not admit programming functions G63 (rigid tapping) and G192
(turning speed limitation) in the same block.
SOLUTION Program both instructions in different blocks.
1249 'Gear change is not possible while G96 is active'
DETECTION During execution.
CAUSE The CNC has tried to change the spindle gear (G112) while function G96 was active.
SOLUTION Cancel function G96 to make the spindle gear change.
1251 'Manual mode is not possible while G96 is active'
DETECTION During execution.
CAUSE The CNC has tried to access the jog mode while function G96 was active.
SOLUTION Cancel function G96 to access the jog mode.
1252 '#FREE AX: The face turning axis cannot be eliminated while G96 is active'
DETECTION During execution.
CAUSE The CNC has tried to eliminate the face axis from the configuration of the channel
(#FREE AX) while function G96 was active.
SOLUTION Cancel function G96 to eliminate the face axis from the configuration of the channel.
1254 'G192 and M19 not allowed in the same block'
DETECTION During execution.
CAUSE The CNC does not admit programming functions M19 (spindle orientation) and G192
(turning speed limitation) in the same block.
SOLUTION Program both instructions in different blocks.
To Next Page
Loading...
