Error solving manual.
CNC 8060
CNC 8065
·59·
(REF: 1709)
1495 '#PROBE1: wrong axis for probing cycle'
DETECTION During execution.
CAUSE The PROBE1 cycle issues the error because the main three axes of the current
configuration are not the same as the main three axes of the initial configuration.
SOLUTION Restore the initial configuration of the first three axes of the channel.
1496 '#PROBE1: programming not allowed while #TOOL AX[-] is active'
DETECTION During execution.
CAUSE The CNC has tried to execute the PROBE1 cycle while the tool is oriented in the
negative direction of the axis.
SOLUTION Program #TOOL AX[+] before executing the PROBE1 cycle to orient the tool in the
positive direction of the axis.
1497 'Wrong operator for the type of variable'
DETECTION During execution.
CAUSE The CNC has tried to change a non-numerical variable using the operators "+=", "-
=", "*=" amd "/=".
SOLUTION Check the program.
1499 'Too many nesting levels of #RPT and subroutines'
DETECTION During execution.
CAUSE It is considered nesting when the #RPT instruction is programmed between two labels
that defined the influence area of another #RPT instruction. The CNC issues an error
when exceeding the number of nesting levels of RPT instructions and subroutines,
if any.
SOLUTION The maximum number of nesting levels allowed is 20.
1500 '#EXEC: the program cannot be executed in the indicated channel'
DETECTION During execution.
CAUSE Using the #EXEC instruction, the CNC has tried to execute a program in a channel
that is in error, is executing another program or is in jog mode and cannot switch into
automatic mode.
SOLUTION Wait for the program to finish in the other channel or reset it.
1501 'Labels repeated in #RPT'
DETECTION During execution.
CAUSE In the #RPT instruction, the starting and finishing labels are the same.
SOLUTION Define different starting and finishing labels.
1502 'The variable requires programming an array index'
DETECTION During execution.
CAUSE It is an array variable and the index has not been indicated.
SOLUTION Check the list of variables in the manuals.
1503 'The variable requires programming an axis'
DETECTION During execution.
CAUSE It is an axis variable and the axis name has not been indicated.
SOLUTION Check the list of variables in the manuals.
1504 'The variable does not allow programming an array index'
DETECTION During execution.
CAUSE The syntax of the variable is wrong.
SOLUTION Check the list of variables in the manuals.
1505 'The variable does not allow programming an axis'
DETECTION During execution.
CAUSE The syntax of the variable is wrong.
SOLUTION Check the list of variables in the manuals.
To Next Page
Loading...
