High level language
161
#PROBE 9
(·M· model). Circular boss measuring.
#PROBE 10
(·M· model). Rectangular part centering.
#PROBE 11
(·M· model). Circular part centering.
#PROBE 12
(·M· model). Tabletop probe calibration.
#RENAME AX
Rename the axes of the channel.
#RENAME SP
Rename the spindles of the channel.
#REPOS
Repositioning axes and spindles from an
OEM subroutine.
#RET
End of a global or local subroutine.
#ROTATEMZ
Positioning a turret magazine.
#ROUNDPAR
Type of corner rounding.
#RPT
Repeat a group of blocks.
#RTCP
RTCP transformation.
#SCALE
Scaling factor.
#SELECT ORI
Select onto which rotary axes of the
kinematics the tool orientation is calculated
for a given direction on the work piece (part).
#SELECT
PROBE
Probe selection.
#SERVO ON
Activate the closed loop mode.
#SERVO OFF
Activate the open loop mode.
#SET AX
Set a new axes configuration.
#SET OFFSET
Manual intervention. Moving limits.
#SET SP
Set a new spindle configuration.
#SIGNAL
Channels. Activate the mark in its own
channel.
#SLOPE
Acceleration control.
#SPLINE OFF
Akima splines. Cancels spline adaptation.
#SPLINE ON
Akima splines. Activate spline adaptation.
#SWTOUT ON
Activate synchronized switching.
#SWTOUT OFF
Cancel synchronized switching.
#SYNC
Spindle synchronization based on the real
(actual) coordinate.
#SYNC POS
Manual intervention. Coordinate
synchronization.
#TANGCTRL
OFF
Cancel tangential control.
#TANGCTRL
ON
Activate tangential control.
Instruction Meaning
To Next Page
Loading...
