EasyManua.ls Logo

Fagor CO-501 - SAFETY INSTRUCTIONS

Fagor CO-501
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22/07/2019
4
SERVICE MANUAL
EVO FRONT LOADING DISHWASHER
1. INTRODUCTION
Dear customer,
We would like to thank you for the confidence you have placed in our brands and in our product. We are
sure that this machine will meet your requirements.
The equipment must only be used for the purposes established by the manufacturer. Inappropriate use of
the same may result in risks to the integrity and safety of users and damage to the equipment. This machine may
only be used by professionals or qualified personnel. Any other use will be in conflict with the intended use and is
therefore hazardous.
The guarantee does not cover damage to glass components, or damage to insulation material or damage
due to the incorrect installation of the equipment, or to inappropriate use, inadequate maintenance or poor repair
processes.
This Service Manual is a guide to help in the maintenance of the machine.
This equipment is subject to changes and modifications for its technical progress.
2. SAFETY INSTRUCTIONS
For your safety:
Do not store or use inflammable and/or corrosive liquids or gases near the equipment.
The operation of the machine must never be entrusted to minors or individuals with physical, mental or
sensory disability. Nor to individuals without the experience and/or necessary knowledge, unless
under the supervision of a safety manager.
The machine must only be operated by hand. Any damage resulting from the use of sharp, pointed
objects or similar will invalidate all warranty rights.
To avoid the risk of accidents and damage to the machine, operators must receive adequate safety training by
means of relevant courses, seminars and programmes.
Warning: The incorrect adjustment, substandard cleaning or installation, or inadequate maintenance
or service, together with the renovation of the machine may result in property damage and/or personal
injury, or even loss of life. Please read the instructions in the manual supplied with the machine
carefully before starting the machine.
Safety measures for the use of the machine.
- Always open the door very slowly (hot steam) (burn hazard).
- Use suitable protective clothing.
- The exterior temperature of the appliance may reach over 60 °C. Only touch the control elements (burn hazard).
- Cleaning - Aggressive chemical action (risk of abrasion).
During cleaning, always use suitable protective equipment: protective goggles and gloves, face mask, etc. Observe
the safety instructions listed in the section “Cleaning”.
- Do not store explosive, corrosive or inflammable substances inside to the appliance (risk of fire).
The positioning and installation, and all repairs and/or modifications, should always be carried out by an
AUTHORISED TECHNICIAN, in accordance with the applicable legislation of the country or geographical region.
The manufacturer does not accept liability for the consequences if the machine is incorrectly installed.
- It is strictly forbidden to delete, alter, manipulate or suppress the safety devices. Failure to comply with this
warning may result in severe risk for the health and safety of individuals.
Use of spare parts other than original parts will cancel the guarantee.
To prevent the contamination of recipients and to maintain hygiene standards, the elements in contact with
food and surrounding zones should be cleaned after each use.
Before switching on the newly installed appliance for the first time, the inside should be cleaned with a
cloth soaked in soapy water. Then switch on the empty machine for at least two full cycles to eliminate the
odours associated with a new appliance.
This equipment has been designed for use in ambient temperatures between 5 and 40 C.
Do not leave flammable products or objects inside the tub or in its vicinity.

Table of Contents

Related product manuals