Fagor DDS AXD/SPD 2.50 User Manual

Drives
3.
180
Ref.1912
DDS
HARDWARE
· 110 ·
Connectors
Layout
AXD|SPD 1.08|1.15
These drives have the following connectors:
F. H3/46
AXD|SPD 1.08|1.15 modular drives. Connectors.
1. Power connector for motor connection.
2. Power DC BUS that feeds the drives from the power supply through metal plates.
X1. Connector that may be used to establish communication between modules through the internal bus.
X2. Connector for the basic control signals.
X3. Connector with two possible uses:
• as output of the encoder simulator.
• as input of the direct feedback for the position loop.
X4. Connector for motor feedback connection (encoder).
X5. Connector for RS-232 serial line connection.
X6. SERCOS-II or CAN interface connector.
X7. Connector for external acknowledgment of the status of the safety relay.
SL1. Slot for the cards A1, 16DI-8DO and 8DI-16DO.
SL2. Slot for the cards 16DI-8DO and 8DI-16DO.
X4
X3
X1
STATUS
DISPLAY
X5
X6
SL2
SL1
+24Vdc
0 V
SPEED
ENABLE
DRIVE
ENABLE
GND
X7
X2
2.5A(F)
FUSE
(250V)
DR.
O.K.
AS1
AS2
drive MODULE
2
2
+24Vdc
0 V
SPEED
ENABLE
DRIVE
ENABLE
GND
DR.
O.K.
AS1
AS2
RESET button
WARNING. AC touch current greater
than 3.5 mA. Install a ground wire with
a section of at least 10 mm² (Cu) or 16
mm² (Al).
1
X7
SL1
X1
X6
X2
SL2
X4
X3
X5
BOOT button.
Software update & SERCOS|CAN
transmission speed selection.
X6
2

Fagor DDS AXD/SPD 2.50 Specifications

General

Brand	Fagor
Model	DDS AXD/SPD 2.50
Category	DC Drives
Language	English