Fagor DDS AXD/SPD 2.50 User Manual

Connection diagrams
10.
358
Ref.1912
DDS
HARDWARE
· 340 ·
Start-up of the DDS with XPS or RPS power supplies. Block diagram
F. H10/9
Start-up of the DDS with XPS or RPS power supplies. Block diagram.
CONTROL CIRCUITS OF THE POWER SUPPLY WAITING TO BE POWERED
INTERNAL TEST OF THE POWER
SUPPLY
OFF
CLOSE main power
switch Q1
MAIN KEY ON
OK ?
NO
YES
ERROR
ACTIVATION OF THE SYSTEM OK
OF THE POWER SUPPLY
CLOSE contactor K1
Status:
POWER BUS WAITING TO BE POWERED
With emergency line OK
CHANGE THE POWER BUS
OFF
Status:
PowerBusStatus, GV13 = 1
POWER BUS CHARGING
ON
Status:
CONTROL CIRCUITS OF THE DRIVES WAITING TO BE POWERED
INTERNAL TEST OF EACH DRIVE
ALL OK ?
ERROR
See error code at the drive’s
display not ok.
MOTOR TORQUE
ON
Status:
WAITING FOR ACTIVATION OF DRIVE ENABLE & SPEED ENABLE & SYSTEM SPEED ENABLE
OFF
Status:
MOTOR TORQUE
ACTIVATION OF A RESSETABLE ERROR OR DEACTIVATION OF SPEED ENABLE FUNCTION
GP9
0 CATEGORY
STOP
WITH
1 CATEGORY
STOP
ACTIVATION OF HALT
WITH
2 CATEGORY
STOP
ON
Status:
MOTOR TORQUE
PUSH-BUTTON ON
With regenerative power supplies, the energy released while braking is returned to mains. If while returning it, due to the application, the energy saved in the capacitors may generate a higher voltage than the maximum bus voltage allowed, a Crowbar resistor must be installed to dissipate that excess of energy.
OFF
Status:
YES NO
WITH
ACTIVATION OF A NO RESSETABLE ERROR OR DEACTIVATION OF DRIVE ENABLE FUNCTION

Fagor DDS AXD/SPD 2.50 Specifications

General

Brand	Fagor
Model	DDS AXD/SPD 2.50
Category	DC Drives
Language	English