C. Cancel Schedule Setting
Set the schedule time to be “00:00”
Note:
a. schedule setting by robot body is based on the robot system time. So you need to set the robot
system time to be correct first, after that you could set the schedule time.
b. once schedule cleaning time
setting was confirmed, robot will clean automatically every day at
the schedule time. When switch off the robot, the schedule would be canceled, if need the
robot work schedule, need to make schedule setting again.
2. Make Schedule Setting by Remote Control
A. Schedule time setting
a. make sure robot in standb
y or charging status, keep press “PLAN” on remote control over
5 second, remote control will enter schedule setting.
b. left two number on remote cont
rol LCD panel will flashing, press direction keys on remote
control to change the number till you find the time would like to set.
c. when you find the time you c
ould like to set, make the remote control point to the robot,
and then press “ON/OFF” key on remote control to confirm the setting. When setting
success, the LED display panel on robot body will show the schedule time.
Note:
Schedule setting time by remote control is the delay time after current robot system time.
E.g: robot current system time is 8:00 am, time on remote control number Is: 01:30, this
means robot will start work at 9:30am and set this time 9:30am every day as the schedule
time.
B. Cancel Schedule Setting
When remote control in schedule setting status, press again “ON/OFF” key on remote control. (If
robot display 00:00 on robot body that means schedule was canceled, if not, press again “ON/OFF”
to cancel the setting.)
16
To Next Page
Loading...
