Falcon FLO - E-Bike Pedal Assist System (PAS); Power Assistance Levels; Walk Assist Mode

Page 15
Thebikeshaveanelectricpedalassisteddrivingsystem.InEUcountries,itisknownlegallyas“PAS”cycleorPedal
Assisted System.
The driving assisted system consists of a driving unit, a battery, a controller, and various electronic components (harness
wires, sensors and switches). It is important to know that when the assistant system is turned on, the driving unit engages
to provide power only while you are pedaling. The amount of power provided by the drive unit depends on your pedaling
force and the assistance speed/level you set with handlebar control unit at any time, if you stop pedaling, the drive
assistantwilldisengage.Inallspeeds/levels,thedrivingassistedsystempowerreducesprogressivelyandcutso󰀨as
the bike reaches a speed of 25km/h,(15.5mph), or sooner if you stop pedaling. The drive assist re-engages when speed
drops below 25km/h, (15.5mph) as long as the pedals are turning.
• Yourelectricbikeo󰀨ers3di󰀨erentlevelsofpowerassistancewhichyoucanswitchbetweenusingthehandlebar
controller (Fig.1)
• Afterpressingthe“M”buttontoswitchthebikeon,simplypressthe“+/-”button1,2or3timestoswitchbetween
Low,MediumandHighpowerassistance.Pressingita4thtimeswitchestheassistanceo󰀨forthebiketobeped-
alled without assistance, and starts the cycle between modes again.
• Ifyourbikeisttedwitha“6km/h”button,thisistoactivatethe“WalkAssist”mode.Whilstdismountedandpushing
the bike, press and hold this button for the bike to push itself – useful uphills!
Please note: Walk Assist should never be used whilst you are sitting on the bike. This will cause undue wear on the motor
andpotentiallycausedamage.FollowingUKlegislation,allofourelectricbikesarepowerassistonly,nonearettedwith
a throttle and all motors will activate ONLY when you are pedalling.