Falltech Confined Space Davit System - Page 9

4.4 3pc Portable Base Assembly (Applies to both base sizes)
Please see Table 2 in Appendix A for 3pc Portable Base compability.
The davit base legs are shipped in a dierent orientaon to opmize packaging and storage when not in use, Figure 15. To assemble, the
legs must be rotated from the packed posion to the proper orientaon for use. On both legs, remove the detent pins as shown in
Figure 16. Rotate the round tube of the leg to the use posion, as shown in Figure 17. Align the holes of the round tubes and reinsert
the detent pins, as shown in Figure 18.
Figure 15 Figure 16
Figure 17 Figure 18
Before inserng the legs into the base center secon, refer to the table in Figure 19 to match the Base Posion with the Pin Posion of
the Davit Arm. To install the Davit Base Legs, ensure the red thumb screws are loosened (turn counter-clockwise). Insert the legs into the
base center secon and determine the oset your applicaon requires; align the holes and insert the detent pins, Figure 20. Tighten the
red thumb screws (clockwise) to ensure they are locked in place as shown in Figure 21.
1 12 3 4 234
PP1 PP2 PP3 PP4
Yes No No No
Yes Yes No No
Yes Yes Yes No
Yes Ye s Ye s Yes
1
2
3
4
Base
Posion
Base Posions
Davit Arm Pin Posion
Short Long
Narrow
Wide
Figure 19 - 3pc Portable Base Oset Davit Arm Pin Posion Compability Chart
IMPORTANT
021519
MCS30 Rev B
9