The IO-Net is a connection for intelligent network modules. For example, Intelligent Relay Modules (IRM),
Intelligent Digital Modules (IDM) or Intelligent Sensor Modules (ISM).
SYSTEM COMMUNICATION tab page IO-Net
Setting used to reset all data to zero simultaneously.
Setting if the settings of the customer must be run in Simulation Mode.
If no IO-net modules are connected, the control computer doesn't give alarms
during the Simulation Mode.
FNet is the Fancom Network. Several control computers can be linked via this network. FNet is also used to
operate the connected control computers from a PC.
SYSTEM COMMUNICATION tab page FNet
Setting used to reset all data to zero simultaneously.
If there is no S2S communication, the Receive and Transmit counters should be set to 0.
To Next Page
Loading...