System Setup:
A. On screen display Menu:
1) Press “SETUP” to display the main screen of the Setup Menu on the screen
and “General Setup Page” appears. At same time, “General” is highlighted.
Press to select other setting items. Press “SETUP” again to exit the Setup
Menu and the unit will resume it's last playback mode.
2) When “General” is highlighted, Press the “OK” button, “TV Display” is
highlighted.
3) Press the ▲ or ▼ button to select the other menus in general setup page.
4) Press to enter the sub menu.
5) Press the ▲ or ▼ button to select the sub menu and press the “OK” to
confirm your selection.
6) Repeat steps 3-5 for other menus.
Note: Press to return the previous menu.
B. Setting Page:
1. General Settings Page
1.1 Display Mode
a. Normal/PS: When the player outputs signal to a normal monitor. Wide-
screen images are shown on the screen. But with some parts cropped
automatically.
b. Normal/LB: When the player outputs signal to a normal monitor, a normal
picture is shown on the screen with a black strip at both the top and bottom
of the screen.
c. Wide: When the player outputs signal to a wide screen monitor, a wide
picture is shown on the full screen.
1.2 Angle Mark
On: The screen will show the angle mark icon. (If an angle option is available).
Off: The screen will not display the Angle Mark.
Note: Not all discs contain above features. The above features are disc
dependent.
1.3 OSD Language
You can choose one out of several different languages as the OSD setup
language.
1.4 Screen Saver
On: Enables screen saver.
Note: The DVD player will enter the Screen Saver mode after approximately
five minutes if the same image remains on the screen.
Off: Disables screen saver (off).
1.5 Last Memory
On: The unit will return to the last position on the disc.
Off: The unit will not return to the last position on the disc.
2. Audio Setup
2.1 Ch speaker setup
To Next Page
Loading...