Chapter 1 F2000 Series Control System Introduction
6
10) Working Temperature: -10℃~+60 . ℃ Relative Humidity, 0~95%.
1.4 System Interface
a) 15 pins SMA Male interface of 2 axes of motor drive.
b) 25 pins SMA Female interface of 16 channels optoelectronic isolation output
ports max back flow current 300mA.
c) 25 pins SMA Male interface of 16 channels optoelectronic isolation input ports，
max output current 300mA.
d) 5 cores THC motor output and limit input ports.
e) 7 cores arc pressure and position input port, arcing signal output port.
f) Selection of partial pressure proportion of arc input: 1:50 or 1:100
g) USB interface on the front panel, for the convenience of transmitting cutting
code.
h) Extend IO input/output ports, PWM input ports, analog input ports.
1.5 Hardware Configuration
1.5.1 F2100 B/T Hardware Configuration
1. Monitor:7 inch, 800*480, high definition 16 million colors and high
brightness LCD
2. Memory: 64M SDRAM
3. Program space available for user: 256M electronic hard disk
4. System master frequency: 400MHz
5. USB: USB 1.1 front interface, at least 16GB U disk supportable
6. Keyboard: electronic PCB foil keyboard
7. Chassis: full-steel structure completely shielded which defends electromagnetic
radiation, interference and static electricity
1.5.2 F2200 B/T Hardware Configuration
1. Monitor: 8 inch, 800*600, high definition 16 million colors and high
brightness LCD
2. Memory: 64M SDRAM
3. Program space available for user: 256M
To Next Page
Loading...
