FANUC R-J3iB - 4.1 NETWORK-RELATED SETTINGS

B-82604EN/01 OPERATION 4.SETTINGS ON THE ROBOT SIDE
- 9 -
4.1 NETWORK-RELATED SETTINGS
This function uses Ethernet. First, make settings for using Ethernet.
4.1.1 Setting the Host Names, Internet (IP) Addresses, and Subnet
Mask
Display the protocol setup screen of the host communication setup
screen.
On this setup screen, set the following items:
• Node name of the controller
• Node name of the router (Even when there is no router, be sure
to enter a dummy node name.)
• Subnet mask
• Node names and IP addresses of all controllers (including this
controller) that involve robot link communication
For example, the following settings are made:
R-J3 R-J3iB
R-30iA(R-J3iC)
Set system-specific node names and Internet (IP) addresses. Any
names may be used, but they should be intelligible.