How to resolve poor image quality on my FARGO electronics Printer?
To resolve poor image quality on your FARGO electronics Printer, clean the printhead and rollers. This helps remove any buildup that may be affecting the print quality.
How to fix ribbon wrinkle problems with my FARGO electronics Printer?
To fix ribbon wrinkle problems with your FARGO electronics Printer, ensure the ribbon is installed correctly. This can prevent wrinkles and ensure proper printing.
How to adjust image darkness on FARGO electronics Printer?
To adjust image darkness on your FARGO electronics Printer, modify the image darkness setting in the printer driver. This will help you achieve the desired print darkness.
What to do if card image is cut off or off-center on FARGO electronics Printer?
If the card image is cut off or off-center on your FARGO electronics Printer, reposition the card guide. This ensures the card is properly aligned during printing.
How to resolve pixel failure problems on FARGO electronics Printer?
To resolve pixel failure problems on your FARGO electronics Printer, replace the faulty printhead. This should eliminate the pixel failures.
How to fix excessive resin printing on a FARGO electronics Printer?
To fix excessive resin printing on your FARGO electronics Printer, adjust the resin print settings. This will help control the amount of resin used during printing.
How to resolve card surface debris problems on FARGO electronics Printer?
To resolve card surface debris problems on your FARGO electronics Printer, clean the card surfaces carefully. This will prevent debris from affecting print quality.
How to resolve the Flipper Alignment Error Message on FARGO electronics Printer?
To resolve the Flipper Alignment Error Message on your FARGO electronics Printer, recalibrate the flipper mechanism. This should correct the alignment issue.
How to resolve the Printhead Temp Error Message on FARGO electronics Printer?
To resolve the Printhead Temp Error Message on your FARGO electronics Printer, check if the printhead is properly installed. This can often resolve temperature-related errors.
General| Print Resolution | 300 dpi |
|---|---|
| Print Technology | Dye sublimation |
| Card Capacity | 100 cards (standard input hopper) |
| Card Thickness Accepted | 0.040" |
| Interface | USB 2.0 |
| Operating System Compatibility | Windows 7, 8, 10, Server 2008, 2012 |
| Card Sizes Accepted | CR-80 (3.375"L x 2.125"W / 85.6 mm L x 54 mm W) |
| Power Requirements | 100-240 VAC, 50/60 Hz |
To Next Page
