How to resolve reinsert ribbon error on FARGO electronics HDPii Printer?
If your FARGO electronics Printer displays a 'Reinsert Ribbon' error, it means the Ribbon must be reinserted for proper functioning of the Printer. Reinsert the Ribbon or press Resume.
How to fix FARGO electronics HDPii Printer unable to feed card?
If your FARGO electronics Printer is unable to feed a card from the Card Cartridge, verify there are cards in the cartridge. Also, verify cards are not stuck together or jammed, and that they are the correct thickness.
What to do if FARGO electronics HDPii says cover is open?
If your FARGO electronics Printer displays the message that the cover is open, it is because the cover was left open. Ensure that the cover is properly closed.
What to do if FARGO electronics HDPii Printer says card not found?
If your FARGO electronics Printer displays a 'Card Not Found' error, this indicates that the card cannot be found in the Printer. First, verify that the card is not jammed in the Printer, and then select Cancel.
How to fix remove ribbon error on FARGO electronics HDPii Printer?
If your FARGO electronics Printer displays a 'Remove Ribbon' error, it means the print Ribbon is not installed properly or has been damaged. Verify the correct Ribbon is installed in the Ribbon Cartridge. Remove it and replace it with the correct Ribbon.
How to resolve E-Card Encoder Startup Error on FARGO electronics HDPii?
If your FARGO electronics Printer displays an 'E-Card Encoder Startup Error', it means a problem was detected during Printer start-up. Reset the Printer and try again. If this problem persists, call for technical assistance.
How to fix head resistance error on FARGO electronics HDPii Printer?
If your FARGO electronics Printer displays a 'Head Resistance' error, it means the EE setting in Driver for head resistance is out of range. Enter a value for head resistance in the EE settings in the Driver. Reset the correct value according to the steps in the Troubleshooting Section. If this problem persists, call for technical assistance.
How to resolve head voltage error on FARGO electronics Printer?
If your FARGO electronics Printer displays a 'Head Voltage Error', it means a hardware fault has prevented setting the correct Printhead voltage. Reset the Printer and try again. If this problem persists, call for technical assistance.
How to fix FARGO electronics HDPii card jam during transfer?
If a card became jammed in your FARGO electronics Printer during transfer, clear the jam.
How to fix FARGO electronics HDPii Printer card jam in PROX area?
If your FARGO electronics Printer has a card jammed in the PROX card encoding area, clear the jam.
Details the printer's technical attributes including card thickness, types, cleaning, colors, capacity, interface, and dimensions.
Describes key components like the printhead, card cartridge, output hopper, and interface ports.
Provides critical safety instructions and warnings for printer installation to prevent injury or damage.
Guides on loading essential supplies like print ribbons, transfer film, cleaning rollers, and blank cards.
Step-by-step instructions for installing the printer driver software from the CD or web.
Lists and explains various messages displayed on the printer's LCD screen.
Provides tables for LCD and printer error messages, including causes and solutions.
Guides on setting up network parameters like IP address, subnet mask, and DHCP.
Provides procedures to resolve issues with Ethernet printer connectivity and printing.
Details how to install printer driver updates and set up the printer driver.
Provides instructions on how to download and install new firmware for the printer.
General| Brand | FARGO electronics |
|---|---|
| Model | HDPii |
| Category | Printer |
| Language | English |
To Next Page
