FARGO electronics HDPii - Ethernet Option Section

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDPii High Definition Card Printer/Encoder User Guide (Rev. 1.1)
vi
Adjusting the Ribbon Type_________________________________________________________ 7-27
Adjusting the Film Type___________________________________________________________ 7-29
Using the Dual Sided Group Functions__________________________________________________ 7-30
Using the Dual Sided - Print Both Sides option _________________________________________ 7-31
Using the Print Both Sides - Split 1 Set of Ribbon Panels option ___________________________ 7-32
Using the Print Both Sides - Print Back Image on Front of Card option ______________________ 7-33
Using the Dual Sided - Print Back Side Only option _____________________________________ 7-34
Using the Device Options Group ______________________________________________________ 7-35
Using the Rotate Front 180 Degrees or Rotate Back 180 Degrees options ____________________ 7-36
Using the Disable Printing option____________________________________________________ 7-37
Using the Image Color tab _____________________________________________________7-38
Using the Quality – Color Matching dropdown _________________________________________ 7-40
Adjusting for the Resin Dither ______________________________________________________ 7-44
Using the Advanced Image Color window_____________________________________________ 7-45
Using the Default button on the Image Color tab________________________________________ 7-51
Using the Image Transfer tab___________________________________________________7-52
Adjusting the Image Position controls ________________________________________________ 7-53
Adjusting the Transfer Dwell Time and Temperature ____________________________________ 7-55
Using the Default button___________________________________________________________ 7-59
Using the Magnetic Encoding tab _______________________________________________7-60
Using the Encoding Mode dropdown_________________________________________________ 7-61
Selecting the Coercivity/Magnetic Track ______________________________________________ 7-65
Reviewing the Shift Data Left Function_______________________________________________ 7-66
Reviewing the Magnetic Track Options_______________________________________________ 7-67
Using the Magnetic Track Options___________________________________________________ 7-69
Using the Character Size buttons ____________________________________________________ 7-71
Using the ASCII Offset dropdown list ________________________________________________ 7-72
Using the Bit Density dropdown list__________________________________________________ 7-73
Using the LRC Generation dropdown list _____________________________________________ 7-74
Using the Encoding Mode dropdown list ______________________________________________ 7-75
Reviewing the ISO Track Locations__________________________________________________ 7-76
Sending the Track Information______________________________________________________ 7-77
Reviewing the Sample String _______________________________________________________ 7-78
Reviewing the ASCII Code and Character Table________________________________________ 7-79
Using the Default button (Image Transfer tab)__________________________________________ 7-80
Using the K Panel Resin tab____________________________________________________7-81
Using the Scroll controls __________________________________________________________ 7-82
Using the Click and Drag capability__________________________________________________ 7-83
Selecting “inches or mm” radio button________________________________________________ 7-83
Using the Add and Delete buttons ___________________________________________________ 7-83
Selecting the Full Card ____________________________________________________________ 7-84
Selecting the Defined Area(s)_______________________________________________________ 7-85
Selecting the Undefined Area(s)_____________________________________________________ 7-86
Defining the Area to activate the Card Grid____________________________________________ 7-87
Measuring the Total Card area ______________________________________________________ 7-88
Measuring the Area to be positioned on the Card________________________________________ 7-89
Selecting the Print YMC under the K and Print K Only options ____________________________ 7-90
Using the Printer Supplies tab __________________________________________________7-92
Reviewing Information on the Supplies tab ____________________________________________ 7-93
Section 8: Inhibit Panel Usage_______________________________________________8-1
Using the Inhibit Panel (HDPII) _________________________________________________8-1