Do not rotate the crane before the load
is lifted.
Do not operate with sudden move-
ments, activate the controls with slow
and progressive movements; rotate
slowly and with care paying attention to
the stability of the vehicle.
With vertical lift, on hydraulic and
mechanical extension, rotate slowly in
order to avoid side-skidding.
(!) ATTENTION (!)
Do not utilize the crane for pushpull
(F), lateral (F) or sideways (F) opera-
tions.
(!) ATTENTION (!)
Crushing (F) or push (F) manoeuvres
are not permitted.
(!) Never operate the outriggers
when the crane is loaded.
(!) ATTENTION (!)
The vehicle\crane must not be left
unless the load is on the ground, the
booms of the crane (and of the
hydraulic jib), are folded and laid on
a solid base and the power take-off
is disengaged.
Do not move the vehicle if a load is suspended on the crane.
C0.3 At the end of the operation (Prior to driving the vehicle)
Fold the crane.
If the booms of the crane of the crane
(or of the hydraulic jib) are to be laid on
the body or on the load, they must be
suitably blocked to prevent possible
sideways movements.
Make sure that the indications about
the overall dimensions are respected.
NOTE
Implements can be left mounted on the booms of the crane (or of the hydraulic
jib) only if the overall dimensions are respected; they must be suitably blocked to
prevent possible sideways movements.
Make sure that the outrigger supports and rams are re-entered within the overall
width of the truck and locked by the safety devices.
Disengage the power take off.
C0.3
WARNING AND
INSTRUCTIONS
F 170A
8
To Next Page
Loading...