Fastcorp DIVI - Page 31

Fastcorp, LLC
DIVI Setup and Users Guide
Page 31 of 62 Rev 6
G. AUTO VENDS –
Used internally to cycle-vend machines under test. Machine will automatically cycle through all
programmed selection numbers repeatedly at 3 minute intervals until option is turned off. After
Auto Vends is enabled, pull Service Switch “out”. Push the Service Switch “in” to stop. Go back to
8) Auto Vends and follow instructions to turn Auto Vends “OFF”.
H. SET SERVICE PHONE #
Enter, update, or view your service phone number. This programmed number will appear on the
display screen in the event that the machine goes out-of-order.
I. SALES PIN CODE -
View or change the PIN code that will allow access to Sales Meters without opening the door.
While in “Please Insert Money” mode, Press # * and the four numbers you selected.
Display
Programming Instructions
8) AUTO VENDS
a) Press the #=Yes key to enter menu option.
* = Next
D = Back
# = Yes
AUTO VENDS
N
b) Press *-Change to scroll from “N” to “Y”
*-CHANGE
#-EXIT
AUTO VENDS
Y
c) Auto Vends is “ON”. Press # -EXIT menu. Pull out
button on the Interlock/Service Switch to begin cycle.
*-CHANGE
#-EXIT
*-EXIT
#-SAVE
AUTO TEST IS ON
d) Momentary display.
Display
Programming Instructions
9) SET SERVICE PHONE #
a) Press the #=Yes key to enter Menu Option.
* = Next
D = Back
# = Yes
Phone (###) ### - ####
b) Type in service phone number. Use the “ABCD” code
to format your service phone number. A=( , B=) ,
C=SPACE , D= -
* save
ABCD=( ) _ -
# ex
Phone (555) 555 - 1234
c) Press *save to save your service number and exit.
Display
Programming Instructions
10) SALES PIN CODE
a) Press the #=Yes key to view or change sales pin code.
* = Next
D = Back
# = Yes
Sales PIN: #*1234
b) Sales Pin Code is factory set at #*1234. Use factory
setting or type over four new digits and press the #-Save
key. Type this code when you are in “Please Insert
Money” mode to gain direct access to Sales Meters.
*-EXIT
#-SAVE
SAVED
c) Press # to save the new PIN