Fastcorp DIVI - Page 32

Fastcorp, LLC
DIVI Setup and Users Guide
Page 32 of 62 Rev 6
J. VEND BLOCK -
Block out vending up to four times per day, seven days per week. Time and date must be entered
correctly in SET TIME and DATE programming. *NOTE: When Vend Block is ON, vending is OFF.
K. VB PIN CODE
Set or alter the VEND BLOCK option from the outside of the machine without opening the door by
using a PIN code.
Display
Programming Instructions
11) VEND BLOCK
a) Press the #=Yes key to enter Menu Option.
* = Next
D = Back
# = Yes
1 BEGIN
01:00
b) Enter the start time for the first Vend Block. Press
*=Save to store time.
*-SAVE
#-NEXT
1 BEGIN
01:00
c) Enter “1” for AM or “2” for PM. Display will advance.
1-AM
2-PM
BEGIN PERIOD 1
d) Block 1 “on” time is displayed momentarily.
1:00am
1 END
10:00
e) Type the time you want vending to resume and press
*- Save.
*-SAVE
#-NEXT
1 END
10:00
f) Enter “1” for AM or “2” for PM. Display will advance.
1-AM
2-PM
END PERIOD 1
g) Block 1 “off” time is displayed momentarily.
10:00AM
Sunday
OFF
h) Press # - Next to scroll through all days, press *-
Change to select a day.
*-CHANGE
#-NEXT
SAVED
i) After scrolling through all days to Saturday, display
will show that your choices have been saved.
2 BEGIN
12:00AM
j) Enter the start time for the second Vend Block or
press # to exit.
*-SAVE
#-EXIT
Display
Programming Instructions
12) VB PIN CODE
a) Press the #=Yes key to enter Menu Option.
* = Next
D = Back
# = Yes
VB PIN
#*5678
b) Vend block pin code is factory set at #*5678. Use
factory setting or type over four new digits and press
the #-Save key. Type this code when you are in “Please
Insert Money” mode to gain direct access to VEND
BLOCK.
*-EXIT
#-SAVE
SAVED
c) Press # to save the new PIN.