STBM
Anti-rattle Adjustable
Aluminum Ball Mount
Use and Care Instructions
For Ball Mount Models
2 Inch Receiver: DT-STBM6400, DT-STBM6600, DT-STBM6800, DT-STBM7000
2.5 Inch Receiver: DT-STBM6425, DT-STBM6625, DT-STBM6825, DT-STBM7025
Congratulations on your purchase of a new Fastway® Flash™ STBM ball
mount. e anti-rattle features of the STBM ball mount allow you to
enjoy the beauty and convenience of a premium adjustable aluminum
ball mount, with the least amount of receiver clunk and rattle noise
possible. Read these instructions thoroughly to become familiar with
proper set up and maintenance procedures. is will ensure that your
Flash ball mount will give you maximum performance, and years of
service.
KEEP THESE INSTRUCTIONS in a safe place for future reference.
IMPORTANT SAFETY INFORMATION
Failure to follow all safety warnings may result in severe
injury or death.
Please register your product warranty. See warranty information on back.
Proudly Made in the USA
1
2
3
4
5
6
7
8
9
10
Date of Purchase:
BALL
SIZE
MAX
TRAILER
WT. LBS.
MAX
TONGUE
WT. LBS.
2”
8,000
1,000
2
5
/16 ”
10,000
1. Receiver tension pin
2. Drop bar (shown in down or drop position)
3. Positioning indicator notches
4. Safety lock bolt
5. 5/16” security hex tool
6. Ball holder tension bolt
7. Ball holder
8. Dual hitch ball
9. Height adjustment holes
10. Receiver tube tension bolt
• Read, understand, and follow all safety warnings,
setup, use, and maintenance instructions of your
trailer, tow vehicle, and hitching equipment before
installing your Flash ball mount or towing your trailer.
• Never cut, weld, grind, bend, heat, or modify ball
mount components in any way.
• It is the driver’s responsibility to properly install and
adjust the equipment and to adjust driving habits to
match towing conditions. e driver is responsible for
their own safety and the safety of passengers.
• Never exceed the specied weight ratings for the
trailer, tow vehicle, receiver hitch, ball mount, hitch
ball, or any other towing equipment.
• Always use a hitch ball size that correctly matches
your trailer coupler size and make sure it is coupled
securely before towing.
• Do not impact the ball mount on the ground. Do not
back into things with your ball mount or an attached
trailer (i.e. loading docks, trees, etc.). If your ball
mount has been impacted in any way, thoroughly
inspect it for damage before towing, and if it is bent or
damaged DO NOT tow; replace it.
• Do not loosen ball holder tension bolt while the ball
mount is under load from an attached trailer.
• Check all towing hardware before each trip. Do not tow
your trailer until all pins and bolts have been checked
for wear, visually verifying that the ball holder tension
bolt is properly seated into the height adjustment hole,
and the safety lock bolt is properly tightened.
• Do not tow with ball mount if height adjustment holes
show excessive wear.
To Next Page
Need help?
General
