FSIN0318
877-523-9103 • 353 South 1100 West • Provo, UT 84601 • fastwaytrailer.com
Limited Lifetime Warranty
Progress Mfg. Inc. warrants the Fastway
FORTRESS Coupler Lock against latent
defects in materials and workmanship under
normal use and service, ordinary wear and
tear, chrome, and corrosion are excepted,
from the first date of purchase at retail for the
ownership life of the original purchaser. If this
product is latently defective it will be replaced
or repaired when a proper return authorization
is obtained and the product is returned with
transportation charges prepaid to the Progress
Mfg. Inc. manufacturing plant. Progress Mfg.
Inc. shall not be required to replace or repair
any products damaged as a result of improper
installation, alteration, unreasonable use,
forced removal, or improper maintenance.
This warranty does not include labor charges
nor does it include transportation charges for
returning the product to the consumer. To the
extent allowed by law, Progress Mfg. Inc. shall
not be liable for any incidental, consequential,
or any other damages including, without
limitation, breach of any implied warranty,
merchantability, or fitness for a particular
purpose of any Fastway product. In no event
shall Progress Mfg. Inc. be liable for any
damages other than the replacement or repair
of the affected part. Authorization and warranty
procedure may be obtained by calling Progress
Mfg. Inc. customer support at 877-523-9103.
6. Rotate the key back to the 12:00 position to
remove it from the lock. Do not force the key
(in either direction). ‘Jiggle’ the lock bar and
shackle slightly if needed to align the lock
teeth and shackle to release the key.
7. To remove the lock, insert the key and turn it
to the 3:00 position. Pull the shackle up out
of the lock bar. Open the coupler latch and
release the lock bar.
8. Regularly apply a light weight oil or spray-
type lithium grease to the lock cylinder and
latch rods. We recommend a few drops of
good quality air-tool oil.
Instructions for Use
1. To install the FORTRESS
®
, insert the key and
rotate it clockwise to the 3:00 (1/4 turn) posi-
tion to release the shackle from the lock bar.
2. Open the coupler latch on the trailer.
3. Place the lock bar into the coupler with the
detent ball up inside the coupler socket, and
the lock facing forward.
4. Close the coupler latch.
5. Slide the shackle down through the lock bar
until both lock bar and shackle are tight to
the trailer coupler. For highest security, the
top bend of the shackle should be pointing
toward the trailer body whenever possible.
To Next Page
Need help?
General
