FAURE HERMAN 744-082 - Storage

FAURE-HERMAN
COMPONENT MAINTENANCE MANUAL
744-082 / 744-082-3
28-49-91
PAGE 704
JULY 17/13
Fit 4 screws (410) fitted with washers (420) into both corner plates (350) and both brackets (560).
F. Installing "Power supply" PC board (190)
Install "Power supply" PC board (190), then fit 4 screws (200) fitted with washers (210) into both
corner plates (350) and both brackets (560).
Solder the PC board connecting wires.
G. Installing the casing (30)
Engage casing (30) through the rear of the equipment and slide into position against face panel
(130). Fit 4 screws (40) and 4 screws (50).
3. STORAGE
A. Short-term storage
For storage not exceeding two months and under normal atmospheric conditions, proceed as
follows:
(1) Protect the receptacle connector with a plastic cap.
(2) Wrap the unit in kraft paper.
(3) Place the wrapped unit in a heat-seal cover.
(4) Heat-seal the cover, enclosing as little air as possible.
(5) Place the assembly in a cardboard box provided with internal shock-proof padding.
(6) Close the cardboard and seal the seams with adhesive tape.
(7) Identify the package with a label.
B. Long-term storage
For prolonged storage or storage under particularly hazardous environmental conditions (salt air,
excessive humidity, etc.), the unit must be packed in a crate or a special container.
(1) Place the assembly packed as above in a crate.
(2) Pad the assembly using appropriate material.
(3) Close the crate.
(4) Mark the package with the following : unit description, serial number, date of packing.
C. Removal from storage
Carry out a functional test when removing the unit from storage and before setting it into operation.
The document reference is online, please check the correspondence between the online documentation and the printed version.