9
FAVERO Electronics - 0259-0902A Assioma user manual _Rev21 - EN-IT-DE
ENGLISH
Important warnings to avoid communication problems during pairing:
• Make sure there are no other power meters switched on nearby (10 m).
• The bike computer must be within 2 m from Assioma.
• For Bluetooth devices only: make sure Assioma has not already been paired
or connected via Bluetooth to another device or app.
• If you set Assioma DUO in “Dual channel L/R” mode, the right pedal sensor
can be recognized by the R ID identication number written on the outside
of the box. For more information, see Chap. 17.
9.2. Conguration of power elds
Once the pairing procedure has been completed (Chap. 9.1), it is possible to congure
the bike computer so that it displays the power data in the preferred way: please refer
to the bike computer manual.
It is recommended to at least set the following parameters: 3 second power, 30 second
power, cadence, 30 second average balance.
9.3. Crank-arm length
The crank-arm length affects power calculation: Assioma must know this length. An
incorrect value will lead to incorrect power values.
Please refer to the bike computer manual to learn how to set the crank-arm length.
If the crank-arm length cannot be set on the bike computer, set this parameter using
the Favero Assioma App.
Do not set the crank-arm length via the Favero Assioma App if the bike computer
already allows this operation; the set value would be overwritten.
10. Manual and automatic calibration (zero-offset)
Each Assioma sensor is factory calibrated to ensure its guaranteed precision under any
operating conditions, including ambient temperature variations, for which automatic
compensation from -10°C to +60°C is active.
No return to the Manufacturer is therefore necessary for periodic factory calibration.
With the 4.75 rmware update, Assioma introduces the automatic calibration (zero-offset)
functionality, a sophisticated algorithm considering different aspects over time.
The only suggested precaution is to store the bike upright (not tilted), with no load
applied on the pedals. Automatic calibration is independent of the crank position.
Manual calibration is, therefore, not necessary, yet it is possible to keep on performing
it in a few seconds via the Assioma app or bike computers/third-party-apps. By doing
so, the values registered by the last automatic calibration will be overwritten by those
of the manual one.
To Next Page
Loading...
Need help?
General