To Next PageTo Next Page
Need help?Do you have a question about the FCI FC-72 Series and is the answer not in the manual?
General| Brand | FCI |
|---|---|
| Model | FC-72 Series |
| Category | Fire Alarms |
| Language | English |
Recommended operating temperature and humidity limits for the equipment.
Guidelines for proper wiring practices, including power limitations and grounding.
EMC testing and system reacceptance test requirements.
Describes the inherent limitations and potential failure points of fire alarm systems.
Emphasizes ongoing maintenance and immediate repair for system failures.
Details jumper positions and their functions for the BMFC/ZMC.
How to use a voltmeter to check specific test points for troubleshooting.
Explains the operation of switches on BMFC and zone modules.
Procedures for identifying and locating ground and short circuit faults.
Lists jumper functions and matrix configurations for the BMFC.
Details connection and troubleshooting for the municipal box interface.
Details output parameters for auxiliary alarm outputs.
Steps to configure the system for presignaling operation.
Describes NAC circuits, their capabilities, and available modules.
Detailed wiring instructions for Class A, Style Z NAC Circuit 1.
Instructions for Class B, Style Y wiring for NAC circuits.
Lists common problems, causes, and actions for NAC circuit issues.
Guide to determining required wire size using the provided chart.
Details common alarm and trouble dry contacts and their relays.
How to connect and use the optional 3-wire remote trouble indicator.
Importance and method for connecting earth ground per NEC.
Details the output for 4-wire smoke detectors and limitations.
Information on ZDM, its features, and compatibility.
ZDM settings for coded operation and waterflow detection.
Details ZDM-D features, wiring, and jumper settings.
Steps to diagnose and resolve "Zone Trouble" LED indications.
Explains VZM functionality, including its verification time cycle.
VZM settings for coded operation and waterflow detection.
Specific jumper settings required for ZDM-D on BMFC/ZMC.
ZDM-D settings for coded operation and waterflow detection.
Procedure for using ZDM for sprinkler supervisory service.
How to connect remote zone annunciators to ZDM or VZM.
Details alarm and trouble zone signal outputs.
Requirements for connecting sealed lead calcium rechargeable batteries.
How trouble LEDs identify circuit issues and component failures.
Chart to calculate required battery capacity based on current draw and hours.
Wiring diagram for connecting the Potter ATTE-B transmitter.
Wiring diagram for connecting Versus STU units.
Wiring diagram for connecting Keltron DMP-703/704.
Configuration for waterflow and supervisory connections.
Details requirements for FCI approved, U.L. listed smoke detectors.
Information on PSD/CPD detector base options and compatibility.
Wiring diagrams for various 2-wire detector base configurations.
Typical wiring diagram for Model SBS smoke detectors.
Typical wiring diagram for Model 301 smoke detectors.
Detailed explanations of jumpers, relays, and diode jumper positions.
