INR-SI47-1246a
- 1 -
Installation Manual
Remote Keypad "TP-E1U"
Thank you for purchasing the remote keypad "TP-E1U." Using this keypad allows you to operate the
FRENIC-MEGA/Mini/Ace/VP/Lift series of inverters remotely and locally. To operate the inverter remotely, use a remote
operation extension cable (CB-5S, CB-3S or CB-1S) or commercially available LAN cable to connect the remote keypad to the
inverter. You can run and stop the motor, specify the function codes, monitor the running status, and perform data copying
(read the function code data from an inverter, copy (write) it into another inverter, or verify it).
1. Acceptance Inspection
Check the following:
(1) The package contains a remote keypad and its installation manual
(this book).
(2) There have been no problems during transportation. In particular, no
parts are damaged or have fallen out of place nor are there any
dents on the body.
(3) The model name "TP-E1U" is inscribed on the back of the remote
keypad as shown in Figure 1.
(4) In case of using this keypad for the FRENIC-Ace / VP / Lift series,
check the stamps under the model name, as shown in Figure 1.
The model which has "D" to “Z” of the first character of the stamps
allows to be applied for FRENIC-Ace / VP / Lift series.
Note that the data copy function is not available in FRENIC-Ace / VP /
Lift series if the first character of the stamps is "A" to "C".
Figure 1 Back of Remote Keypad
If you suspect the product is not working properly or if you have any questions about your product, contact your Fuji Electric
representative.
2. Inverters with which the Remote Keypad Interfaces
The remote keypad "TP-E1U" interfaces with the following Fuji inverters:
Type of inverter Series name Remarks
FRN G1 - FRENIC-MEGA
FRN C2- FRENIC-Mini
FRN E2 - FRENIC-Ace The data copy function is valid in the remote keypad which
has the first character of the stamps "D" to "Z" under the
model name on the back of the keypad. (Refer in Figure 1)
FRN F2 - FRENIC-VP
FRN LM2 - FRENIC-Lift
3. Installation and Connection
To mount the remote keypad to the panel and other devices except inverters, use a remote operation extension cable
(CB-5S, CB-3S or CB-1S) or commercially available LAN cable.
(1) Parts required for connection
In addition to the inverter, the following parts are required.
Parts name Model Remarks
Remote operation extension cable
(Note 1)
CB-5S, CB-3S and CB-1S
Three types available in length of 5 m, 3 m, and
1 m
Fixing screw M3 (Note 2) Two screws (prepared by the customer)
(Note 1) When using a commercially available LAN cable, select a 10BASE-T/100BASE-TX straight type cable compliant
with US ANSI/TIA/EIA-568A Category 5. (Less than 20 m)
Recommended LAN cable (for 1 m) Manufacturer : Sanwa Supply Inc.
Model : KB-10T5-01K
KB-STP-01K (Shielded LAN cable, EMC-compliant)
(Note 2) Use screws with the length suitable for the wall thickness of the panel. (Please refer to Figure 2.3)
(2) Installation procedure
After finishing the wiring for the inverter, proceed to the following steps. Turn OFF the inverter power.
Stamps
First character
Model name
Dealers Industrial Equipment -- Visit https://DealersElectric.com or call (908) 688-1966 for all of your electric motor & VFD needs!
To Next Page
Need help?
General