EasyManua.ls Logo

FeelElec FY8300S Series - User Manual

FeelElec FY8300S Series
52 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FeelElec
FY8300S Series Fully Numerical Control
Three +Four Channel Function/Arbitrary Waveform
Generator
User’s Manual
Rev1.0 May,2019

Table of Contents

Questions and Answers

  • R
    Ricky LarsonAug 5, 2025
    What to do if my FeelElec Inverter set correctly, but no waveform output?
    • B
      blakealanAug 5, 2025
      If your FeelElec Inverter isn't outputting a waveform despite correct settings, here's what to check: * Ensure the BNC cable is securely connected to the CH1, CH2, or CH3 connector. * Inspect the BNC cable for any internal damage. * Verify the BNC cable is properly connected to your testing instrument. * Confirm that the indicator lights for CH1, CH2, or CH3 are illuminated. If not, press the corresponding button to activate them.
  • R
    rfritzAug 15, 2025
    How to fix FeelElec Inverter screen if it is still dark after switch on?
    • J
      Jennifer SmithAug 15, 2025
      If the screen of your FeelElec Inverter remains dark after switching it on, try the following: 1. Ensure the power is correctly connected. 2. Verify that the power switch is fully engaged. 3. Restart the device.
  • U
    ujordanAug 25, 2025
    Why are CH2 and CH3 locked on my FeelElec Inverter?
    • L
      Linda SmithAug 25, 2025
      To unlock CH2 and CH3 on your FeelElec Inverter: 1. Verify that the signal generator is operating in synchronous state. Press the SYNC button to access the synchronization settings and cancel any synchronization parameters. 2. If the issue persists, restart the generator.

Summary

Product Information and Setup

Product Title and Overview

Identifies the instrument as the FY8300S Series Signal Generator User's Manual.

Guaranty and Declaration

Covers copyright, declarations, and contact information for the product.

Quick Start Guide

Guides users through initial setup and basic operations of the instrument.

Front Panel Operations

Front Panel Overview

Describes the layout and components of the instrument's front panel.

Waveform Generation

Explains how to output and configure waveforms, including channel selection and parameter setting.

Example Output

A step-by-step example demonstrating how to output a sine waveform.

Advanced Functions and System Management

Burst and Modulation Functions

Covers configuring burst waveforms and various modulation types.

Frequency Meter;Counter

How to use the built-in frequency meter and counter functions.

Sweep Functions

Explains how to configure and perform sweep operations (frequency, amplitude, etc.).

System Configuration

Covers system settings like language, buzzer, save/load, uplink, and synchronization.

Troubleshooting and Specifications

Troubleshooting

Common problems and their solutions for the instrument.

Technical Specifications

Detailed technical specifications and performance characteristics of the device.

Accessories and Warranty

Lists standard accessories, options, and warranty information for the generator.

FeelElec FY8300S Series Specifications

General IconGeneral
Output WaveformPure Sine Wave
Input Voltage12V/24V/48V
Output Voltage110V/220V AC
Output Frequency50Hz/60Hz
Protection FeaturesOverload, Over Voltage, Short Circuit, Over Temperature, Low Voltage
CoolingFan
Operating Temperature-10°C to 50°C

Related product manuals