Feig Electronic VEK M2E-2-B - 1 General

VEK M2E-2 Operating instructions
4 03/06 FEIG ELECTRONIC GmbH
1. General
The induction loop detector is a system used for inductive vehicle detection.
Range of application:
• Barrier controls
• Door- and gate controls
• Parking- and traffic engineering
Characteristic features:
• evaluation of two loops
• galvanic separation of loop and detector electronics
• automatic system adjustment directly after switch-on
• continuous rebalancing of frequency drifts in order to avoid environmental influences
• suitable for individual job control
• no influence on loop 1 and loop 2 through multiplexing
• sensitivity adjustment independent of loop inductivity
• occupied-signal emitted by LED-display
• potential-free relay contacts as outputs
• Relay triggering may be converted from static current- to operating current principle by
switch operation.
• loop breach- or loop closing message via LED-signal
• indication of occurred and eliminated loop failures
• indication of base frequency by flash signals of the green LED
• diagnosis by external diagnostic device
• 11-pole circular connector
Possibilities of adjustment:
• two frequency levels to be used by both channels
• four sensitivity levels per channel
• Holding time: 5 minutes or infinite for both channels
• presence- or directional detection
• permanent- or pulse signal for relay channel 2
• permanent direction signal or pulse direction signal l
Structural shape:
• Housing 76x38x71mm (HxWxL) with 11-pole circular connector, RAL 5005
• 2 boards, 72x65mm each
For planning and installation of induction loops, please refer to our manual „vehicle detection
with the induction loop detector“.