Feig Electronic VEK MNH2-R24-C User Manual

SENSORS
DE
ACHTUNG!
WICHTIGE SICHERHEITSHINWEISE!
Folgen Sie den Anweisungen auf Seite 3 dieser Anleitung.
FR
ATTENTION!
IMPORTANTES INDICATIONS DE SÉCURITÉ!
Les instructions de la page 3 de cette notice de montage
doivent être observées strictement.
ES
¡ATENCIÓN!
¡INDICACIONES IMPORTANTES DE SEGURIDAD!
Deben seguirse las indicaciones detalladas en página 3 de
estas instrucciones de montaje.
IT
ATTENZIONE!
INDICAZIONI SULLA SICUREZZA IMPORTANTI!
Prestare attenzione alle note alla pagina 3 delle presenti
istruzioni di montaggio.
NL
LET OP!
BELANGRIJKE VEILIGHEIDSINSTRUCTIES!
Volg de instructies op pagina 3 van deze
montagehandleiding op.
DA
PAS PÅ!
VIGTIGE SIKKERHEDSANVISNINGER!
Oplysningerne på side 3 i denne monteringsvejledning
skal følges.
VEK MNH
Traffic detector
Operating manual
EN
IMPORTANT!
Read carefully before use!
Keep for future reference!
Safety instructions on page 12!

Feig Electronic VEK MNH2-R24-C Specifications

General

Brand	Feig Electronic
Model	VEK MNH2-R24-C
Category	Security Sensors
Language	English

Summary

Safety and warning information

Proper use

Product overview

Scope of delivery

Technical data

Product description

Product versions

Product characteristics

Product functions

Description of connections

Power supply

Explains how to connect the power supply to the detector.

Loop inputs

Details the connection of induction loops to the detector's terminal blocks.

Signal outputs

Describes the available signal outputs, including relay and open collector types.

Assembly and electrical installation

Assembly on the DIN rail TS35

Instructions for mounting the device onto a TS35 DIN rail.

Connecting the power supply

Step-by-step guide for connecting the detector's power cable.

Connect the relay outputs (versions -R24)

Instructions for wiring the relay outputs of the R24 variants.

Connecting the open collector outputs (versions -024)

Instructions for wiring the open collector outputs of the 024 variants.

Connecting the induction loops

Details on how to connect the induction loops to the detector.

Commissioning

Description of functions

LED status indicators

DIP switch settings

Description of settings

Adjusting sensitivity (switch-on threshold)

Guide to setting the sensitivity and switch-on threshold of the detector.

Setting hysteresis (switch-off threshold)

Explains how to adjust the hysteresis or switch-off threshold.

Setting loop frequency (frequency step)

Instructions for setting the loop frequency to prevent interference.

Setting hold time

Details on how to configure the hold time for loop occupation.

Setting output mode (signal type)

Inverting output signal (Signal behaviour)

Behaviour in the event of loop error (error mode)

Assigning an output to a loop (Assignment)

Setting output switching time (impulse time)

Setting output times (output time behaviour)

Setting direction detection (dual-channel variants)

Setting direction logic (dual-channel variants)

Maintenance & servicing

Decommissioning