EasyManuals Logo

Feig Electronic VEK MNH2-R24-C User Manual

Feig Electronic VEK MNH2-R24-C
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
Maintenance & servicing
VEK MNH Operating Manual v1.3 en
51 | 56
12 Maintenance & servicing
NOTE
Maintenance and repairs
This product does not require any maintenance or servicing.
In the event of malfunctions and faults, please contact the vendor or the manufacturer.
13 Decommissioning
Conditions
System not functioning
The system is not in use.
All work must be carried out by qualified specialists.
Tools
Tools for the system
Always comply with the manufacturer’s instructions!
Insulated slotted screwdriver (width 2 3 mm)
Decommissioning the detector
1. Switch off all components of the system (observe the manufacturer’s instructions).
2. Switch off the power supply to the detector.
3. Check that there is no voltage to any of the supply cables.
The detector can be detached.
4. Carefully press down the mounting bracket with the screwdriver and pull the detector off the DIN rail.
5. Pull the terminal blocks out of the input and output sockets.
The detector can be detached. Remove all connectors as follows:
6. Loosen the screws holding the terminal blocks with a slotted screwdriver.
7. Pull the cable out of the mounting slots.
The detector is disassembled.
At the end of its service life, dispose of the product in accordance with the valid legal
specifications.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Feig Electronic VEK MNH2-R24-C and is the answer not in the manual?

Feig Electronic VEK MNH2-R24-C Specifications

General IconGeneral
BrandFeig Electronic
ModelVEK MNH2-R24-C
CategorySecurity Sensors
LanguageEnglish

Related product manuals