VEK MNH Operating Manual v1.3 en
11 Description of settings
The functions described below can be performed with the Detector Tool service program as well as with the
DIP switch. The DIP switch provides the key default settings. Commissioning is not possible without the service
program.
• You can run diagnostics and perform further settings with the Detector Tool.
• If the settings are changed with the Detector Tool, the blue LEDs flash continuously.
• In order to reset to factory settings, hold the reset button down for 5 seconds.
Printed designations of the default versions and designations provided in the Detector
Tool are show in brackets.
Information in this column shows the settings options for the DIP switch.
Information in this column shows the settings available in the Detector Tool.
Information in this document
This document refers to the default settings or default values defined by the manufacturer. The factory
settings of customer variants may differ from the manufacturer’s specifications. Please observe the
instructions on the device, as well as the documents supplied with it.
To Next Page
Loading...
