Fein KBM80U - Starting the Drill Motor

19
en
Start drill motor.
➤ To start the motor with clockwise
rotation, press the button with the „ “
symbol. The motor starts with the high-
est speed.
➤ The last set speed is automatically
stored (memory function). To start the
power tool with the last set speed, press
and hold the button with the „ “
symbol, and then press the button with
the „ “ symbol.
➤ To lower the speed, press the „ “
button.
➤ To stop the drill motor, press the
„ “ button.
➤ Do not stop the drill motor during the
drilling procedure.
➤ To start the motor with anticlockwise
rotation, press the button with the „ “
symbol. The drill motor will run as long
as the button is pressed.
When the power supply is disconnected
while the motor is running, a protective cir-
cuit prevents automatic restarting of the
motor. Restart the motor again.
In case of overload, the motor automatically
stops and must be restarted again.
3 41 01 126 21 0.book Seite 19 Donnerstag, 21. Januar 2010 1:48 13