itself of trapped air. Observe coolant levels and maintain as recommended by adding
coolant to the recovery bottle. We recommend the use of a 50/50 mixture of high
quality aluminum compatible anti-freeze coolant and distilled water.
NOTE: Always follow the manufacturer’s mixing recommendations for the freeze
protection required in your area.
Cooling System
WARNING
Never remove the pressure cap when the engine is warm or hot. Escaping steam can
cause severe burns. The engine must be cool before removing the pressure cap.
Radiator Coolant Level Inspection
NOTE: This procedure is only
required if the cooling system
has been drained for maintenance
and/or repair. However, if the
recovery bottle has run dry, the
level in the radiator should be
inspected and coolant added if necessary.
NOTE: Use of a non-standard pressure cap will not allow the recovery system to
function properly. If the cap should need replacement, contact your dealer for the
correct replacement part. To insure that the coolant maintains its ability to protect the
engine, it is recommended that the system be completely drained every two years and
a fresh mixture of antifreeze and water be added.
Using a funnel, slowly add coolant as necessary through the radiator filler neck.
To Next Page
Loading...