2626
#
!
"
#
"
!
Edgebander with glue pot
G 200 / G 220
Per edge tape width there are different devices. These
devices must be attached onto the infeed fence to have a
parallel guide of the workpiece.
0,4 – 0,8 mm no device necessary
1– 1,5 mm 1 mm device
2 mm 2 mm device
! Edge guide 1
" Edge guide 2
# Handle grip
! Devices
" Infeed fence
# Fixing screws
Making adjustments and preparations
8.6 Infeed fence
Fig. 16: Infeed fence
Pull the tape manually until it reaches the edge guides.
The lower guide is adjusted to the height of the worktab-
le.
The fence must be adjusted to the width of the edge tape
(the upper guide is justified). The knob adjusts the width.
The vertical play must be within 0,5 mm.
Attention! Never loosen the fixing screws of the infeed fence!
8.5 Edge tape fence
Fig. 15: Edge tape fence
To Next Page
