Return to previous menu.
General info
Total printed time in hours
Total extruded filament in meters.
Choose your language
Extruder settings
Currently active extruder (see white square in front)
X-offset of extruder (this is only used for extruder 2)
Y-offset of extruder (this is only used for extruder 2)
Motor steps to extruder 1mm of filament
Start feedrate of extrusion
Maximum feedrate of extrusion
Acceleration of extrusion
Temperature stabilization time.
Filament retraction amount when printer is waiting to reach temperature
Waiting temperature during pause
Extruder linear advance parameter.
Extruder quadratic advance parameter.
Heating strategy, standard PID control
Proportional control value
Integral control value
Derivative control value
Minimum PID control value
Maximum PID control value
Maximum PID value
Build platform control
Build platform coating setting, used to add offset between nozzle and bed after
homing.
Heating strategy, standard PID control
Proportional control value
Integral control value
Derivative control value
Minimum PID control value
Maximum PID control value
Maximum PID value
Set communication baudrate between printer, must reboot printer to activate.
Save changed settings.
To Next Page
Loading...
