9 Maintenance
Dust cleaners
Filament attracts a lot of dust and small particles. Make sure the filament enters the filament holder through the dust
cleaner. After a few months of printing it is recommended to replace the dust cleaners.
Motion system
The linear bearings require almost no maintenance. Recommended is that you put a little some grease on them every
3-4 months.
The belt tension of the x and y axis can also be checked in intervals of 3 months. Check this small movie to see how to
tension the belts.
https://www.youtube.com/watch?v=dpS6nWn5rE8
To Next Page
Loading...