What to do if my Fellowes Starlet 2 120 Binding Machine will not punch?
If your Fellowes Binding Machine won't punch, it might be due to a blockage. First, ensure the waste tray is empty. Then, check for any obstructions in the paper entry.
Why does my Fellowes Binding Machine produce damaged hole edges?
Damaged hole edges in your Fellowes Binding Machine output are possibly due to overloading the machine. Try punching plastic covers together with paper sheets. Also, consider reducing the number of sheets you're punching at once.
What to do if the waste tray leaks in my Fellowes Starlet 2 120 Binding Machine?
If the waste tray of your Fellowes Binding Machine is leaking, it could be that the waste tray isn't correctly inserted or the ‘burst feature’ has been activated. Ensure the waste tray is empty and the ‘burst feature’ is closed.
How to fix partial holes when using Fellowes Starlet 2 120?
Partial holes in your Fellowes Binding Machine output indicate that the sheets are not correctly aligned to the punch pattern. Adjust the edge guide and test punch some scrap sheets until the alignment is correct.
Why are the punch holes not parallel to the edge on my Fellowes Starlet 2 120 Binding Machine?
If the punch holes are not parallel to the edge when using your Fellowes Binding Machine, debris might be stuck below the dies. Take a piece of stiff cardboard and slide it into the paper entry. Move the cardboard sideways to dislodge any stray clippings into the waste tray.
How to center punched holes with a Fellowes Binding Machine?
If the punched holes are not central when using the Fellowes Binding Machine, the edge guide may not be set correctly. Adjust the edge guide until the hole pattern is correct.
Provides crucial advice for safe operation and maintenance.
Lists specific safety guidelines to follow during the punching process.
Solutions for off-center, non-parallel, or partial punched holes.
Addresses machine not punching, damaged edges, or overload.
Details the 2-year warranty, limitations, and consumer rights.
Provides crucial advice for safe operation and maintenance.
Lists specific safety guidelines to follow during the punching process.
Solutions for off-center, non-parallel, or partial punched holes.
Addresses machine not punching, damaged edges, or overload.
Details the 2-year warranty, limitations, and consumer rights.
General| Brand | Fellowes |
|---|---|
| Model | Starlet 2 120 |
| Category | Binding Machine |
| Language | English |
To Next Page