Need help?Do you have a question about the Fender Bassman 800 and is the answer not in the manual?
General| Power Output | 800 Watts |
|---|---|
| Amplifier Type | Hybrid |
| Power Amp | Solid-State |
| Effects Loop | Yes |
| Number of Channels | 2 |
| Footswitch I/O | 1 x 1/4" |
| Footswitch Included | No |
| Effects | Overdrive |
| Preamp Tubes | 2 x 12AX7 |
| EQ | 3-band |
| Inputs | 1 x 1/4" |
| Outputs | 2 x 1/4" |
| Weight | 17 lbs |
| Height | 9.5 cm |
| Depth | 10.5" (26.7 cm) |
| Speaker Configuration | None (head only) |
Connect your bass and adjust the Vintage channel volume.
Passive tone stack for Vintage channel and selection between Vintage/Overdrive.
Gain, Blend, Volume, and active tone stack for the Overdrive channel.
Master volume control and status indicator lights for amplifier operation.
Power switch, IEC inlet, footswitch, tuner, and effects loop connections.
Combination jacks for connecting speaker cabinets, with impedance notes.
XLR OUT, LEVEL, PRE/POST, and GROUND/LIFT for direct audio output.
Step-by-step guide for replacing preamp tubes and safe handling practices.
Addresses no sound, feedback, and microphonic tube problems with specific solutions.
To Next Page