Fender Power Stage 100 Service Manual

POWER STAGE 100
p/n 071-0100-000 (120V)
SERVICE MANUAL
CONTENTS:
Notices
Specifications
Parts lists:
Remote control assembly
PCB assembly
Cabinet assembly
Miscellaneous
Schematics
Service diagram
Fender Musical Instruments Corp. 7975 North Hayden Road Scottsdale, AZ 85258
POWER STAGE 100
(This is the model name for warranty claims)
FEBRUARY 1997
IMPORTANT NOTICE:
The information contained herein is CONFIDENTIAL and PROPRIETARY to Fender Musical Instruments Corp. It is
disclosed solely for use by qualified technicians for purposes of equipment maintenance and service. It is not to be
disclosed to others without the expressed permission of Fender Musical Instruments Co. All specifications subject to
change without notice.
For warranty repair service, only Fender specified part numbers are to be used. It is recommended they also be used
for post-warranty maintenance and repair.
Parts marked with an asterisk (
*
) indicate the required use of that specific part. This is necessary for RELIABILITY
and SAFETY requirements. DO NOT USE A SUBSTITUTE!
A coded naming convention is used in the description of certain parts. The codes and what they mean are as follows:
CAPACITOR CODES HARDWARE CODES
CAP AE = Aluminum Electrolytic BLX = Black Oxide
CAP CA = Ceramic Axial CR = Chrome Plated
CAP CD = Ceramic Disk HWH = Hex Washer Head
CAP MPF = Metalized Polyester Film M = Machine Screw
CAP MY = Mylar NI = Nickel Plated
CAP PFF = Polyester Film/Foil OHP = Oval Head Phillips
PB = Particle Board
RESISTOR CODES
PHP = Pan Head Phillips
PHPS = Pan Head Phillips Sems
RES CC = Carbon Comp SMA = Sheet Metal "A" Point
RES CF = Carbon Film SMB = Sheet Metal "B" Point
RES FP = Flame Proof SS = Stainless Steel
RES MF = Metal Film TF = Thread Forming
RES WW = Wire Wound ZI = Zinc Plated
1

Fender Power Stage 100 Specifications

Power

voltage (120 V version)	120 VAC, 60 Hz 360 W
voltage (230 V version)	230 VAC, 50 Hz 360 W
voltage (240 V version)	240 VAC, 50 Hz 360 W

Preamp Specifications

system gain Mic 1	0 dB to +90 dB
preamp gain Mic 1	0 dB to +60 dB
input level nominal Mic 1	-28 dBV
system gain Mic 2	0 dB to +90 dB
preamp gain Mic 2	0 dB to +60 dB
input level nominal Mic 2	-28 dBV
system gain Aux Line	0 dB to +60 dB
preamp gain Aux Line	0 dB to +28 dB
input level nominal Aux Line	-21 dBV

Filter Specifications

low cut corner frequency	-3 dB @ 30 Hz to 270 Hz
low notch center frequency	200 Hz to 2 kHz
high notch center frequency	600 Hz to 6 kHz

Headphones

maximum output 8 Ω	14 mW
maximum output 300 Ω	165 mW

Power Amp

nominal power	100 W into 8 Ω
maximum power	108 W into 8 Ω
frequency response	+0 dB, -3 dB 20 Hz to 40 kHz

Weight and Dimensions

height	18 in 45.7 cm
width	23.5 in 59.7 cm
depth	12 in 30.5 cm
weight	45 lbs 20.4 kg