If the amp is set up but does not function, check the following items:
• Is the power cord properly plugged into an electrical outlet?
• Is there power at the outlet?
• Is the speaker properly connected to the amplifier?
• Are all the control knobs turned above zero?
• Is the volume control on the instrument turned up?
• Is the instrument properly plugged into the amplifier?
(Eliminate any effects pedal and try using another cord.)
If after checking all of the above your amplifier is still not performing correctly,
consult your authorized Fender Service Center.
TROUBLESHOOTER'S CHECKLIST
The Roc Pro 700 utilizes one Fender special design
12AX7A tube (part #099-5091). For continued opti-
mum performance from your amplifier, this tube
should only be replaced with a tube of the same
type and specification.
TUBE REPLACEMENT
TOLEX COVERING CARE
Your Roc Pro 700 is covered in genuine Tolex for
long life and lasting good looks. To clean the Tolex
covering, use a sponge and a light soapy water
solution. Avoid spilling liquids on the operating
surfaces, grill, volume and tone controls, switches
and speakers. ALWAYS unplug your amplifier
before cleaning or approaching it with fluids.
9
To Next Page
Loading...
