Fender Rumble Bass - Specifications; Type; Power Requirements; Fuse Type

SPECIFICATIONS
PART NUMBER: 100V version: 081-2170-000
120V version: 081-2100-000
230V version: 081-2160-000
240V version: 081-2130-000
TYPE: CSR 10
DIMENSIONS: Height: 10 in. (25.4cm)
Width: 24.5 in. (62.2cm)
Depth: 13.5 in. (34.3cm)
Weight: 70 lbs. (31.75kg)
POWER REQUIREMENTS: 100V version: 100 volts AC, 50/60 Hz, 900W
120V version: 120 volts AC, 60 Hz, 900W
230V version: 230 volts AC, 50 Hz, 900W
240V version: 240 volts AC, 50 Hz, 900W
FUSE TYPE: 100V and 120V version: F10A, 125V min.
230V and 240V version: F5A, 250V
INPUT IMPEDANCE: Input A: 2.5 M ohm
Input A/B: 2.0 M ohm
Input B: 2.5 M ohm
EFFECTS LOOP: Output Impedance: 42.5 k ohm
Input Impedance: 1 M ohm
EFFECTS MIX CONTROL: Continuously variable between the signal at the EFFECTS
SEND and the EFFECTS RETURN jacks.
PRE-AMP OUT: -9.5 dBV nominal output.
POWER AMP IN: -9.5 dBV nominal input sensitivity.
BALANCED LINE OUTPUT: Derived from the output transformer, fully balanced.
+1 dBv nominal output.
Pin 1 floating, pin 2 (+), pin 3 (-).
AMPLIFIER LOAD IMPEDANCE: 4 ohm with MAIN SPEAKER only.
2 ohm with EXT. SPEAKER included.
AMPLIFIER DAMPING FACTOR: 3.1 at 4 ohms
POWER OUTPUT: 300 Watts, 5% THD into 4 ohms.
SUGGESTED SPEAKER
ENCLOSURES: 081-3100-000 Rumble bass 410
081-3101-000 Rumble bass SUB
081-3102-000 Rumble bass 115
WARNING: NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.
WARNING: TO REDUCE THE RISK OF FIRE OR SHOCK HAZARD,
DO NOT EXPOSE AMPLIFIER TO RAIN OR MOISTURE.