SR-6520 / SR-8520 /P / PD
POWERED MIXERS w/ DIGITAL EFFECTS
SR-6520P p/n 071-6521-100 (120V)
SR-8520P p/n 071-8521-100 (120V)
SR-6520PD p/n 071-6521-200 (120V)
SR-8520PD p/n 071-8521-200 (120V)
SERVICE MANUAL
CONTENTS:
Notices
Specifications
Circuit description
Parts lists:
Preamp PCB assy
Front panel assy
Pwr amp PCB assy
Rear panel assy
Cabinet assembly
Miscellaneous
Dig rev cntrl
Schematics
Service diagram
Fender Musical Instruments Corp.
7975 North Hayden Road Scottsdale, AZ 85258
SR-6520P/PD SR-8520P/PD
(These are the model names for warranty claims)
MARCH 1998
IMPORTANT NOTICE:
The information contained herein is CONFIDENTIAL and PROPRIETARY to Fender Musical Instruments Corp. It is
disclosed solely for use by qualified technicians for purposes of equipment maintenance and service. It is not to be
disclosed to others without the expressed permission of Fender Musical Instruments Co. All specifications subject to
change without notice.
For warranty repair service, only Fender specified part numbers are to be used. It is recommended they also be used
for post-warranty maintenance and repair.
Parts marked with an asterisk (
*
) indicate the required use of that specific part. This is necessary for RELIABILITY
and SAFETY requirements. DO NOT USE A SUBSTITUTE!
A coded naming convention is used in the description of certain parts. The codes and what they mean are as follows:
CAPACITOR CODES HARDWARE CODES
CAP AE = Aluminum Electrolytic BLX = Black Oxide
CAP CA = Ceramic Axial CR = Chrome Plated
CAP CD = Ceramic Disk HWH = Hex Washer Head
CAP MPF = Metalized Polyester Film M = Machine Screw
CAP MY = Mylar NI = Nickel Plated
CAP PFF = Polyester Film/Foil OHP = Oval Head Phillips
PB = Particle Board
RESISTOR CODES
PHP = Pan Head Phillips
PHPS = Pan Head Phillips Sems
RES CC = Carbon Comp SMA = Sheet Metal "A" Point
RES CF = Carbon Film SMB = Sheet Metal "B" Point
RES FP = Flame Proof SS = Stainless Steel
RES MF = Metal Film TF = Thread Forming
RES WW = Wire Wound ZI = Zinc Plated
To Next Page
Need help?
General
