◎ Cree XP-G (R5) LED with a lifespan of 50,000 hours
◎ Uses one 1.5V AA (Ni-MH, Alkaline ) battery
◎ 105mm (Length) x 21.5mm (Diameter)
◎ 54-gram weight (excluding battery and holster)
◎ Digitally regulated output - maintains constant brightness
◎ Reverse polarity protection, to protect from improper battery installation
◎ Anti-roll, slip-resistant body design
◎ Tactical tail cap switch with momentary-on function
◎ Side mode switch in the front
◎ Made of durable aircraft-grade aluminum
◎ Premium Type III hard-anodized anti-abrasive finish
◎ Toughened ultra-clear glass lens with anti-reflective coating
Notice: The above-mentioned parameters (tested by 2500mAh Ni-MH battery in Lab) are
approximate and may vary between flashlights, batteries and environments.
Operation Instruction
The tail cap switch is the power switch and the side button is the mode switch.
Press the tail cap switch lightly to activate the flashlight momentarily (without any press, it will be
off); Press the tail cap switch completely to turn on the flashlight and lock it. Another press can
turn it off.
When the flashlight is on, a single press on the side mode switch can select the brightness levels in
the order of Turbo→ Low→Mid→High→Cycle;
Press and hold the side mode switch for about one second to enter into the Strobe. It will flash in
the frequency of 6Hz/15Hz and transfer the frequency in every 2 seconds.
Press and hold the side mode switch for about 3 seconds to enter into the SOS.
Under the condition of Strobe or SOS, a single press on the side mode switch can return to the
general mode.
The flashlight can memorize the brightness levels in the general mode except the mode. When
turn it on, it will begin to work in the general mode.
Battery Specifications
To Next Page
Loading...
