Page 11 of 17
Rudolf Dieselstraat 15A, Nijverdal, Nederland. +31 523 0613439. Mail: Info@ferlin.nl
Start and stop
The Ferlin One can be started by pressing the start button:
This turns the start button into a stop button. The Ferlin One can be stopped by pressing this button.
Injection moulding machine start-up
When starting up the injection moulding machine (and flushing), the Ferlin One should be set to stop.
This means that the start button should be visible. (If the stop button is visible, the Ferlin One is still
in run mode).
When starting automatic production with the injection moulding machine, the Ferlin One should also
be started by pressing the start button.
To Next Page
Loading...