Page 8 of 17
Rudolf Dieselstraat 15A, Nijverdal, Nederland. +31 523 0613439. Mail: Info@ferlin.nl
Controller
The controller is displayed below:
Help function
The Ferlin One features a help function. Press the question mark in the top right corner to get
explanations about the content on the screen.
Setting up the One
The Ferlin One controller should be connected to the dosing section via 3 cables. Connect the 9, 15
and 25-pole d-sub connectors to the controller and the housing (2). Then connect the power cable to
the controller. In addition, the Ferlin One needs to be supplied with compressed air. This connection
is located on the side of the housing (2). In the following section the explanation of how to connect
the dosing signal and (optionally) connect the potential-free alarm contact is treated.
To Next Page
Loading...