11
EN
cloth dampened with soapy water. Never use
solvents such as benzene, alcohol, ammonia, etc.
These types of solvents can damage the plastic
parts.
Problem solving
1. The motor does not start
• Theplugisnotinthesocket.
• Thepowercordisbroken.
• Theswitchisdefective.Takethemachine
to your dealer for repair.
2. The saw cut is not even (jagged)
• Thesawblademustbesharpened.
• Thesawbladeismountedbacktofront.
• Thesawbladeiscloggedwithresinor
sawdust.
• Thesawbladeisnotsuitableforthepiece
of work being used.
3. The height and/or mitre lever is obstructed
• Chipsand/ordustmustberemoved.
4. The motor has difficulty in reaching full
speed
• Theextensioncordistoothinand/ortoo
long.
• Themainsvoltageislessthan230V.
5. The machine vibrates excessively
• Thesawbladeisdamaged.
6. The machine becomes excessively hot
• Theventilationslotsareblocked.Clean
them out with a dry cloth.
7. The electromotor runs unevenly
• Thecarbonbrushesarewornout.Replace
the carbon brushes or consult your dealer.
Lubrication
The machine does not need any extra lubrication.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.