5
EN
counterclockwise and insert the bit into the
chuck opening.
counterclockwise while simultaneously holding
the rear sleeve (11) or turning it clockwise.
The chuck has a lock function; you will hear a
couple of “clicks” once the bit is tightened.
Setting depth stop
Fig. A
counterclockwise.
side handle ring.
clockwise
The On/Off switch
Fig. A
(5) the machine will turn off.
raising the rotation-speed or release pressure
for lowering the rotation-speed.
Lock-on Button
Fig. A
lock-on button (4).
Adjusting of the maximum rotation speed
Fig. A
switch (5).
lock-on button (4).
adjustment wheel (6) to the desired maximum
rotation speed.
Switching the direction of rotation
Fig. A
Do not change the direction of rotation
during use.
”.
rotation switch (7) to “ ”.
Function selection switch
Fig. A
In order to avoid damage to the machine,
adjusting the function selection switch (2)
shall only be done when machine is not
running
drilling.
hammer drilling.
User tips
Always use the machine with the side handle
firmly anchored in place - you will not only work
with more comfort, you will also work with more
precision.
Caution: drills and chisels can get very
hot.
Drilling and hammer drilling
concrete, start using a smaller bit for pilot
drilling first , then drill to nominal size.
aware the drill can jam and because of that
machine might suddenly turn (Especially when
drilling deep holes).
let the machine do the work.
To Next Page
Loading...
