EasyManuals Logo

Fermax iLoft DUOX User Manual

Fermax iLoft DUOX
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
Page 12
T
+
A
-F1
B
in
B
in
B
out
B
out
5"
¸
T
+
A
-F1
B
in
B
in
B
out
B
out
b) Programming the phones address via the doorbell.
Note: Only if the phone has not been previously programmed, that is, if no address has been saved.
Telephone not yet programmed, red LED blinks.
With the telephone connected and hung-up:
1. Press the door bell or short terminals "T"
and "-".
Upon performing this operation you hear
a doorbell.
Note: Optional: pick up the telephone to establish
communication with the entry panel to indicate which
residence you are in.
Doorbell
Doorbell
2. After 5 seconds short or maintaining the
door bell pressed, the entering program-
ming tone sounds.
After this moment you can stop shorting or
pressing the door bell. While in this mode:
3. Press the button/residential call code from
the panel. A con rmation tone will sound
on the telephone. The telephone is pro-
grammed, (red led off)
Note: The time from which you hear the con rmation
beep for entering in telephone programming, and the
call is made from the panel to program the phone’s
address, must be less than 2 and half minutes.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fermax iLoft DUOX and is the answer not in the manual?

Fermax iLoft DUOX Specifications

General IconGeneral
BrandFermax
ModeliLoft DUOX
CategoryIntercom System
LanguageEnglish

Related product manuals