Page 15
BEEP BEEP
+
2. From this point every time you press the
button, the output audio channel will activate
(you will hear the telephone on the panel) and
a constant blue led will light up.
On releasing the button the input
audio
channel will activate (you will hear the panel
on the telephone) and the intermittent blue led
will light up.
Once you enter “simplex mode” it will remain
activated by default. The next time the audio is
connected, the input channel will activate when
you press the
button (short press).
3. To re-establish "handsfree" conversation mode
once the audio channel is open, press F1 and
the
button simultaneously until you hear a
BEEP BEEP,
(a fi xed blue light)
audio channel
Entry Panel -> Residence
audio channel
Residence -> Entry Panel
Active audio
With the telephone in conversation mode you can slide the controller to change the input
audio volume to one of the 8 possible levels. In this case the volume level of the ringtone
does not change.
Call Volume Regulation
The telephone allows for call ringtone volume regulation and the output audio volume.
Starting from standby mode, use the controller to adjust the call volume to any setting
between the maximum and minimum levels.
Setting the call volume to minimum provokes the disconnection orDo not disturb mode.
In
this mode the led remains fl ashing. To reactivate the ringtone, you must move the controller
above the minimum level.
To Next Page
Loading...
Need help?
General
