EasyManua.ls Logo

FERREX CSP50 - Storage and Transport; Environmental Safety; Fueling the Chainsaw

FERREX CSP50
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
6.3 Storage and transport
Switch o the chainsaw before any transport, even over short distances. Engage the chain
brake and t the chain guard.
Use the chain guard during transport and storage.
Secure the machine against tipping over during transport (including in vehicles) to pre-
vent fuel loss, damage or injury.
Carry the device only by the front handle. In doing so, the guide bar points backwards,
away from your body (see g. L).
Keep the hot silencer away from your body. There is a risk of burns!
Clean and maintain the chainsaw before storage.
Store the device in a safe and dry location. Also secure it from unauthorised access.
6.4 Environmental safety
National and/or municipal regulations may impose time restrictions on the use of
noise-generating, motorized devices. Ask your local administration about this.
The device must not be operated indoors or in other poorly ventilated areas. There is a
danger of suocation due to the toxic exhaust gases / lubricating oil vapours.
Only carry out work in daylight.
Also, do not work in adverse weather conditions, such as rain or wind. There is an increased
risk of accidents here.
Keep your work area clean and tidy.
Keep children, other people and animals away before and during work. If distracted, you
can lose control of the device.
Before starting work, make sure that there are no persons, animals or property in the dan-
ger zone.
Do not work near wire fences or in areas with loose old wire.
Have re extinguishers ready when working in highly ammable environments such as
dry grass, etc. There is a risk of re!
6.5 Filling with fuel
Petrol is very easily ammable. Keep away from naked ames when refuelling and do not
smoke while doing so. There is a risk of re!
Be careful not to spill petrol. Ensure that no petrol or chain oil gets into the soil. Use suita-
ble sheeting or similar to help with this.
Refuel only in well-ventilated areas. Petrol vapours can easily ignite or explode.
Switch o the engine before refuelling and allow the device to cool down. If petrol has
been spilled, clean the aected areas immediately. Also, do not let any fuel get on your
clothes, otherwise change immediately.
Also avoid skin and eye contact with petrol or lubricants (oil).
Do not breathe in fuel vapours/lubricating oil vapours.
Watch out for leaks. If petrol is leaking, do not start the engine. There is a danger from
burns.
Safety information

Related product manuals